CRUISE CONTROL – Nissan Xterra Off Road 2010 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Nissan Xterra Off Road 2010

List of elements for Cruise Control Wiring Diagram for Nissan Xterra Off Road 2010:

• (a/t: on bracket, above brake pedal) stoplight switch
• A/t
• A/t assembly
• Accelerator pedal position (app) sensor (under left side of dash)
• Aps1
• Aps2
• Ascd brake switch (on bracket, above brake pedal)
• Ascd clutch switch (on bracket, above clutch pedal)
• Ascd steering switch
• Ascd sw
• Avcc
• Avcc 2
• Avcc2
• Bncsw
• Brake
• C1 (vih)
• C2 (vout)
• C3 (ghi)
• Can-h
• Can-l
• Cancel switch
• Close
• Combination meter
• Combination switch
• Computer data lines system
• Cruise ind
• E16
• E160
• E24
• Ecm (right rear of engine compt)
• Electric throttle control actuator (on throttle body)
• F502
• F503
• F505
• F54
• Fuse 12 10a
• Fuse 14 10a
• Fuse 19 10a
• Fuse 20 10a
• Fuse block (j/b) (right side of dash)
• Gnd
• Gnd-a
• Gnd-a2
• Hot at all times
• Hot in on or start
• Input speed sensor 1
• Input speed sensor 2
• M/t
• M102
• M30
• M57 (left "a" pillar)
• Motor 1
• Motor 2
• On/off (main) switch
• Open
• Out spd sen gnd
• Out spd sens power out spd sen
• Output speed sensor
• Pnk
• Red
• Resume/ accel switch
• Sensor 1
• Sensor 2
• Set ind
• Set/ coast switch
• Throttle control motor
• Throttle position sensor
• Tps 1
• Tps 2
• Transmission control module
• Transmission range switch
• Unified meter control unit (w/ information display)