Dodge Colt Vista 1991 - FUSES & CIRCUIT BREAKERS Fuses & Circuit Breakers 1984-91 Chrysler Motors
Dodge Colt Vista 1991 - IDENTIFICATION FUSE PANEL IDENTIFICATION (1984-91 MODELS)
Fuse panel is located under instrument panel on driver's side of vehicle. Fusible link wires are used to protect a number of circuits. These links will melt in the event of excessive current flow. Replace after determining cause.
Fig. 1: Dodge Colt Vista 1991 - Component Locations - Fuse Panel Identification (1984-91)
Dodge Colt Vista 1991 - FUSE & CIRCUIT BREAKER IDENTIFICATION 1 - 10 Amp
Dome Light.
Dodge Colt Vista 1991 - 2 - 10 Amp
Stoplights.
Dodge Colt Vista 1991 - 3 - 10 Amp
Hazard.
Dodge Colt Vista 1991 - 4 - 20 Amp (1984-89); Blank (1990-91)
Defogger (1984-89); Not Used (1990-91).
Dodge Colt Vista 1991 - 5 - 20 Amp
Heater.
Dodge Colt Vista 1991 - 6 - 10 Amp
Horn.
Dodge Colt Vista 1991 - 7 - 15 Amp
Wiper.
Dodge Colt Vista 1991 - 8 - 15 Amp
Radio.
Dodge Colt Vista 1991 - 9 - 10 Amp
Turn Signals.
Dodge Colt Vista 1991 - 10 - 10 Amp
Back-Up Lights.
Dodge Colt Vista 1991 - 11 - 10 Amp
Liftgate (1984); Taillights (1985-91).
Dodge Colt Vista 1991 - 12 - Blank
Not Used.
Dodge Colt Vista 1991 - CAUTIONS & WARNINGS BATTERY
WARNING: When battery is disconnected, vehicles equipped with computers may lose memory data. When battery power is restored, driveability problems may exist on some vehicles. These vehicles may require a relearn procedure. See the COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION section.
Dodge Colt Vista 1991 - SUPPLEMENTAL RESTRAINT (AIR BAG SYSTEM) (IF EQUIPPED)
WARNING: The Diagnostic Energy Reserve Module (DERM) can maintain enough voltage to cause a deployment of the Inflator Module for up to 10 minutes after the Ignition Switch is turned off and the battery is disconnected. Many of the service procedures require disconnection of the Inflator Module to avoid an accidental deployment.