TRANSMISSION
A/T Wiring Diagram for Nissan Sentra SL 2007
List of elements for A/T Wiring Diagram for Nissan Sentra SL 2007:
- (front of engine)
- (left side of transaxle) park/neutral position switch
- A/t check
- Atf temp sens
- Batt
- Can-h
- Can-l
- Chip select (sel1)
- Clock (sel2)
- Combination meter
- Computer data lines system
- Cvt device (under front of center floor console)
- Cvt fluid temp sensor
- Cvt unit (left side of transaxle)
- D range sw
- Data i/o (sel1)
- E43
- Ecm (on left side of firewall)
- F9 (front of engine)
- Fuse 10a
- Fuse 20a
- Fuse block (j/b) (behind left end of dash)
- Gnd
- Hot at all times
- Hot in on or start
- Ign
- Ipdm e/r (intelligent power distribution module engine room) (left front of engine compt)
- K-line
- L range sw
- L/u&select- on/off sol
- L/u&select-liner sol
- Line pressure solenoid valve
- Lock-up select solenoid valve
- M61
- N range sw
- O/d control sw
- O/d off
- P range sw
- Pl liner sol
- Pnk
- Pri oil press sens
- Pri speed sens
- Primary pressure sensor
- Primary speed sensor (left side of transaxle)
- R range sw
- Red
- Rom assembly
- S/m-a
- S/m-b
- S/m-c
- S/m-d
- Sec liner sol
- Sec oil press sens
- Sec speed sens
- Secondary pressure sensor
- Secondary pressure solenoid valve
- Secondary speed sensor (top of transaxle)
- Sens power source
- Sensor gnd
- Starting/ charging system
- Step motor
- Tcm (transmission control module) (left front of engine compt)
- Torque converter clutch solenoid valve
- Unified meter control unit
- Vign